focuses on products that can be best produced utilizing our Patent Pending Lo-Waste Molding Technology. This technology is best suited for products with any of the following characteristics (the more of these characteristics - the better):
Low rubber part weight to mold area (typically lighter parts have a lot of rubber waste and the Lo-Waste Molding Technology saves a lot of rubber in these cases)
Expensive rubber material like HNBR, FKM, Fluorosilicone, and other exotic materials
Uncompromised sealing edges like lip seals, cup seals, o-rings or other critical seals for critical applications like Fuel, Braking, Cooling, Heating, Drinking water, etc. ( Flashless Molding used in conjunction with Lo-Waste Molding Technology for critical sealing applications)
Volumes above 100k annually
Less than 5” (127mm) in size
The Lo-Waste Molding Technology allows us to produce all rubber products and rubber over molded to metal or plastics products.
focuses on products that can be best produced utilizing our Patent Pending 
of Products